Pelco C2406M-F REINSTALL CAMERA MODULE, ADJUST POSITION, REPLACE COVER

C2406M-F (4/04) 7

REINSTALL CAMERA MODULE

1. Reinstall the camera module. Refer to Figure 8. Make sure the top of the camera is oriented

properly. On the lens housing, look for the label that says TOP.

WARNING: To prevent damage to the camera or lens, the camera must be

installed in the proper hole of the mounting bracket. If the camera is not installed in

the correct hole, the window of the enclosure may be forced against the lens.

MOUNT CAMERAS WITH

2.9 AND 3.6 MM LENSES

MOUNT CAMERAS WITH

6, 8, AND 12 MM AND

VARIFOCAL LENSES

Figure 8. Camera Installation

2. Reconnect the electrical connections. If you do not need the heater, do not plug in the four-pin

heater connector with red, orange, and black wires.

1. Turn on power to the camera and monitor.

CAUTION: Heater elements could be

hot! When camera power is on, use

caution when adjusting the camera.

This applies to all models.

2. Varifocal Lens Only – Loosen the focal length

and focus locking screws (refer to Figure 9). Adjust

according to scene detail. Retighten the screws.

3. Adjust the position of the camera.

4. Adjustable Mounting Pattern Only – Refer to

Figure 10. Adjust the angle of the base and tighten

mounting hardware. If the watertight mounting

plate is installed, remove the base, adjust the

mounting plate, and reinstall the base.

Place the cover of the ICS200 onto the base of the unit.

Use the screwdriver bit (provided) and tighten the three

tamperproof screws.

VARIFOCAL LENS

LOCKING

SCREWS

Figure 10. Adjustable Mounting Pattern

Figure 9. Varifocal Lens Adjustment