Kenwood KRC-394 Disc magazine is not completely loaded.E01, Load the disc magazine properly

Troubleshooting Guide

English

If the following situations, consult your nearest service center:

•Even though the disc changer is connected, the Disc Changer source is not ON, with "AUX" showing in the display during the Changer Mode.

•Even though no device (KCA-S210A, CA-C1AX, KDC-CPS89, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the Auxiliary input is entered when switching modes.

The following messages are displayed when your system condition.

EJECT:	No disc magazine has been loaded in the changer.
	The disc magazine is not completely loaded.E01
	➪ Load the disc magazine properly.
	No CD in the unit.
	➪ Insert the CD.
NO DISC:	No disc has been loaded in the disc magazine.E02

E-99: Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.E99

➪Check the disc magazine. And then press the reset button on the unit. If the "E-99" code does not disappear, consult your nearest service center.

HOLD:	The protective circuit in the unit activates when the
	temperature inside the automatic disc changer
	exceeds 60°C (140°F), stopping all operation.E0d
	➪ Cool down the unit by opening the windows or
	turning on the air conditioner. As the temperature
	falls below 60°C (140°F), the disc will start playing
	again.
NO NAME:	Attempted to display DNPS during the CD play having
	no disc names preset.E51
NO TITLE:	Attempted to display the disc title or track title while
	the MD having no MD title is being played.E53

➪ Load a disc into the disc magazine.

E-04: No disc has been loaded in the disc magazine.E04

➪Load a disc into the disc magazine.

The CD is quite dirty. The CD is upside-down. The CD is scratched a lot.

➪Clean the CD and load it correctly.

BLANK: Nothing has been recorded on the MD.E10

NO TRACK: No tracks are recorded on the MD, although it has a title.E11

NO PANEL: The faceplate of the slave unit being connected to this unit has been removed.E30

➪Replace it.

E-77: The unit is malfunctioning for some reason.E77

➪Press the reset button on the unit. If the "E- 77" code does not disappear, consult your nearest service center.

NO TEXT:

LOAD:

2 (Blink):

3

NO ACCES:

Attempted to display the disc text or track text while the CD having no CD text is being played.E54

Discs are being exchanged in the Disc changer.E57

The tape player section is not operating properly.E60

➪Reinsert the Tape. If the tape cannot be ejected or the display continues to flash even when the tape has been properly reinserted, please switch off the power and consult your nearest service center.

After setting it in the Disc Changer, DNPP was done without having it been played at least 1 time.E58

— 30 —