IMPORTANT SAFEGUARDS AND WARNINGS
1.Installation and servicing should be done only by qualified service personnel and conform to all local codes.
2.Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6 or 6P enclosure, it is designed for indoor use only and must not be installed where exposed to rain and moisture.
3.Use only installation methods and materials capable of supporting four times the maximum specified load.
4.Use stainless steel hardware to fasten the enclosure to outdoor surfaces.
5.To prevent damage from water leakage when installing an enclosure outdoors, apply sealant around the bolt holes between the enclosure and mounting surface.
DESCRIPTION
The 150 Series Camclosure® Integrated Camera System is an
INSTALLATION
1Install Back Box
Mounting Directly to Wall or Ceiling
1. Cut a hole 3.5 inches (9 cm) in diameter in the ceiling or wall using the adapter plate as a template.
2. Connect the video cable.
3. Connect the power wires.
• For 12 VDC, connect the
24 VAC/12 VDC (red) and GND (black) wires to input power.
•For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power.
4.Attach the back box to the wall or ceiling.
[ 4 ] Pelco Manual