Mounting to 4S Deep Electrical Box
1. Attach adapter plate to the 4S box with the two
2.Connect the video cable.
3.Connect the power wires.
•For 12 VDC, connect the
24 VAC/12 VDC (red) and GND (black) wires to input power.
•For 24 VAC, connect the
24 VAC/12 VDC (red) and
24 VAC (blue) wires to input power.
4S DEEP ELECTRICAL BOX
| WALL OR |
8.32 X .750 SCREW | CEILING |
| |
(SUPPLIED) | ADAPTER PLATE |
| |
| BACK BOX |
8.32 X .375 SCREW | 01063 |
| |
(SUPPLIED) |
|
4. Attach the back box to the adapter plate with the four
Mounting to Ceiling Tile
1. | Remove the ceiling tile. |
|
|
|
|
|
| ADAPTER PLATE | |
|
|
|
|
|
|
|
| ||
2. | Using the adapter plate as a template, cut |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| ||
| a hole 3.5 inches (9 cm) in diameter in the |
|
|
|
|
|
| CEILING TILE | |
| ceiling tile for the back box. Punch four |
|
|
|
|
|
|
|
|
| screw holes in the ceiling tile. |
|
|
|
| ||||
|
| MOUNTING |
|
| BACK BOX | ||||
|
| HARDWARE |
|
| |||||
3. | Attach the back box to the ceiling tile and | (SUPPLIED) |
|
|
|
|
|
| |
|
|
|
|
| |||||
|
|
|
|
|
|
|
| ||
| adapter plate with the four |
|
|
|
|
| 01062 |
| |
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
| |
| screws (see diagram). |
|
|
|
|
|
|
|
|
4.Replace the ceiling tile.
5.Remove an adjacent ceiling tile and connect the video cable.
6.Connect the power wires.
•For 12 VDC, connect the 24 VAC/12 VDC (red) and GND (black) wires to input power.
•For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power.
C A U T I O N
Heater elements could be hot! When camera power is on, use caution when adjusting the camera. This applies to all models.
2Install Camera
1.Some indoor installations do not require a heater. If the installation does not require a heater, remove the heater board from the camera assembly. To remove the heater apply pressure and press on the corner of the board.
HEATER BOARD
1092
Pelco Manual | [ 5 ] |