Pelco C2446M-D <Presets>

30 C2487M-A (4/05)

<Presets>

The Spectra III dome system has 40 programmable preset positions. Each preset can be

programmed to use pan, tilt, all programmable camera settings, and motion detection.

The presets are numbered 1-32 and 35-42. Presets 33 and 34 are fixed commands that cannot be

programmed. Preset 33 is the “flip” command, which will pan the dome drive 180 degrees.

Preset 34 is the “pan zero” command, which will direct the dome drive to the factory-determined

zero reference point.

Use the following steps to program a preset.

1. Select the preset number:

a. Use the joystick to position the cursor beside PRESET NUMBER. Press Iris Open.

The cursor moves to the right.

b. Move the joystick up or down to view selections. Press Iris Open to enter

selection.

2. Edit the preset label:

a. Use the joystick to position the cursor beside EDIT PRESET LABEL.

b. Press Iris Open. The following appears on the monitor:

c. Use the joystick to position the cursor beside a character. Press Iris Open to enter

selection. To clear a character, position the cursor beside BACKSPACE, and then

press Iris Open.

d. When label is completed, move the cursor to OK. Press Iris Open to return to the

Preset menu.

PRESET NUMBER 1

* * * PRESET NOT DEFINED * * *

BACK

EXIT

REFERENCE INFORMATION

AZIMUTH -

ELEVATION -

ZOOM RATIO -

CUSTOM CAMERA SETTINGS -

PRESETS

BACK

EXIT

<ZONES>

<AUX>

<ALERT>*

<CLEAR>

DOME SETTINGS

EXIT

SPECTRA III

LANGUAGE ENGLISH

ACK ALERT*

RESET CAMERA

CYCLE CAMERA POWER

REBOOT SYSTEM

LABEL FOR PRESET

PRESET NUMBER

------

1234567890 OK

ABCDEFGHIJ CANCEL

KLMNOPQRST

UVWXYZ.,-/ SPACE

abcdefghij BACKSPACE

klmnopqrst

uvwxyz*;:

*This setting only applies to

Pressurized Spectra III dome

systems with software version

1.27 or higher.