Pelco C2943M manual Installation, Mounting, Wiring

Installation

MOUNTING

The PVM accommodates mounts that adhere to the VESA® 100 x 100 standard.

For mounting from a ceiling, Pelco recommends using the PMCL-CM mount. This mount can be swiveled 360 degrees, and lets you tilt the monitor 35 degrees for the best viewing angle. This mount must be used with a pole to hang the monitor from a ceiling. The PMCL-CM can support a maximum load of 90 lb (40.8 kg).

For more information and instructions on mounting, refer to the PMCL-CM Monitor Mount Installation manual (C2226M).

For a list of additional mounts, refer to Specifications on page 23.

WIRING

1.On the back of the monitor, loosen the thumb screws and lower the access panel.

2.Attach the leads from the power supply (not supplied) to the left and right connectors, refer to callout 1 in Figure 2 on page 9. For more information about power supplies, refer to Recommended Power Supplies on page 25.

NOTE: Do not connect a ground to the center post.

3.Connect the camera output and any other devices using the connectors, refer to Figure 2 on page 9. Devices that can be connected include DVD players, time-lapse VCRs, and media cards.

4.When finished, secure the access panel.

Table A shows the recommended maximum wiring distances (transformer to load), and are calculated with a 10-percent voltage drop. (Ten percent is generally the maximum allowable voltage drop for AC-powered devices.)

NOTE: For the 26-inch PVM, the maximum VA requirement is 160.8; the maximum current draw is 6.7 A. For the 20-inch PVM, the maximum VA requirement is 96; the maximum current draw is 4.0 A.

Table A. Recommended Wiring Distances

Total VA			Wire Gauge
	20 AWG	18 AWG	16 AWG	14 AWG	12 AWG	10 AWG
Consumed
	(0.5 mm2)	(1.0 mm2)	(1.5 mm2)	(2.5 mm2)	(4.0 mm2)	(6.0 mm2)
100	28 ft	45 ft	71 ft	114 ft	181 ft	288 ft
	(8 m)	(13 m)	(21 m)	(34 m)	(55 m)	(87 m)
160	17 ft	28 ft	44 ft	71 ft	113 ft	180 ft
	(5 m)	(8 m)	(13 m)	(21 m)	(34 m)	(54 m)

8 C2943M (1/08)