4.Remove an adjacent ceiling tile to access the unit.
5.Connect the video cable/wires:
•BNC: Connect the BNC connector from the unit to a mating BNC connector.
•UTP: Blue wire = Video +
Gray wire = Video -
6. Connect the power wires.
Voltage | Red Wire | Black Wire |
|
|
|
12 VDC | + | Ground |
|
|
|
24 VAC | ~ | ~ |
|
|
|
AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one side of the transformer to the red wire on all units; connect the other side of the transformer to the black wire on all units.
NOTE: Failure to connect all AC powered units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
7. Reinstall the adjacent ceiling tile.
IN-CEILING INSTALLATION: FIXED CEILING/WALL
1. | Remove the surface mount ring from the back box (refer to Figure 5 on page 11): |
| ||||
| a. | Place fingers on the circular marks located on the sides of the surface mount ring | . | |||
| b. | Pinch the sides. |
|
|
| |
| c. | Lift and remove the surface mount ring from the back box. Do not discard the surface mount | ||||
|
| ring; it is required to complete the installation. |
| |||
2. | Cut a hole 4 inches (10 cm) in diameter in the ceiling/wall (refer to Figure 8 on page 14). |
| ||||
3. | Pull video and power wires through the opening. |
| ||||
4. | Connect the video cable/wires: |
| ||||
| • | BNC: Connect the BNC connector from the unit to a mating BNC connector. |
| |||
| • | UTP: Blue wire = Video + |
| |||
|
|
| Gray wire = Video - |
| ||
5. | Connect the power wires. |
|
|
| ||
|
|
|
|
|
|
|
|
| Voltage | Red Wire | Black Wire |
|
|
|
|
|
|
|
|
|
|
| 12 VDC | + | Ground |
|
|
|
|
|
|
|
|
|
|
| 24 VAC | ~ | ~ |
|
|
|
|
|
|
|
|
|
AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one side of the transformer to the red wire on all units; connect the other side of the transformer to the black wire on all units.
NOTE: Failure to connect all AC powered units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
13 |
