PTZ MODE
The DX4104 supports up to four serial PTZ cameras. Multiple PTZ cameras can be connected and controlled individually by
The DX4104 allows you to configure the following PTZ settings for each camera:
•Channel: Selects the channel (01 to 04) for PTZ configuration.
•Port: Sets the communication port for the camera: NONE, DATA1, or DATA2.
•Address: Sets the camera’s PTZ control address: 0 to 255.
•Protocol: Sets the PTZ protocol for all cameras on the port. Multiple cameras assigned to a port must use the same protocol. Table B lists the supported device protocols.
•Baud Rate: Sets the baud rate for sending data to all cameras on the selected port: 1200, 2400, 4800, 9600, and 19200.
.
Table A. Supported PTZ Protocols
Protocol Name | Pan/Tilt | Zoom | Focus |
| Iris | Preset | Tour | Setup |
|
|
|
|
|
|
|
|
|
LG_MULTIX | Yes | Yes | Yes |
| Yes | Yes | Yes | Yes |
|
|
|
|
|
|
|
|
|
LG_SD168 | Yes | Yes | Yes |
| Yes | Yes | Yes | Yes |
|
|
|
|
|
|
|
|
|
PELCO_D | Yes | Yes | Yes |
| Yes | Yes | Yes | Yes |
|
|
|
|
|
|
|
|
|
PELCO_P | Yes | Yes | Yes |
| Yes | Yes | Yes | Yes |
|
|
|
|
|
|
|
|
|
GANZ_DSCP | Yes | Yes | Yes |
| Yes | Yes | Yes | Yes |
|
|
|
|
|
|
|
|
|
GANZ_P360V1 | Yes | Yes | Yes |
| Yes | Yes | Yes | No |
|
|
|
|
|
|
|
|
|
KALATEL_CYBERDOME | Yes | Yes | Yes |
| Yes | Yes | Yes | No |
|
|
|
|
|
|
|
|
|
PANASONIC_CS850 | Yes | Yes | Yes |
| Yes | Yes | Yes | Yes |
|
|
|
|
|
|
|
|
|
SAMSUNG_SCC | Yes | Yes | Yes |
| Yes | Yes | Yes | Yes |
|
|
|
|
|
|
|
|
|
BOSCH_AUTODOME |
|
|
| Unsupported at this time. |
|
| ||
|
|
|
|
|
|
|
|
|
LG_ZOOM | No | Yes | Yes |
| Yes | No | No | Yes |
|
|
|
|
|
|
|
|
|
LPT_A100L | Yes | No | No |
| No | No | No | No |
|
|
|
|
|
|
|
|
|
To set up the PTZ mode:
1.From the Camera menu, click PTZ.
2.Click the Channel box, and select the channel to configure.
3.Click the boxes to enter their settings.
4.Repeat step 2 and 3 to configure the other channels.
5.Click Close.
6.Click OK.
C4631M (11/09) | 29 |