VIDEO FORMAT
WARNING: If you change the video format, the unit will delete all existing data, reformat the HDD, and restart.
1.From the Camera menu, click Video.
2.Click the Video Format box, and then select NTSC or PAL. (NTSC is the default.) A warning message appears.
3.Click OK. The unit reformats the HDD and restarts automatically.
NORMAL RECORD MODE
The DX4104 allows you to configure the following recording settings for each camera:
•Channel: Selects the channel (01 to 04) for configuration.
•Resolution: Sets the resolution for the channel. The default is 352 x 240.
Table B. Resolution and Image Rate
| Resolution | Image Rate | |
|
|
|
|
NTSC |
| 352 x 240 | 1, 3, 5, 7.5, 15, 20, 30 |
|
|
|
|
|
| 704 x 240 | 1, 3, 5, 7.5, 15 |
|
|
|
|
|
| 704 x 480 | 1, 3, 5, 7.5 |
|
|
|
|
PAL |
| 352 x 288 | 1, 3, 5, 6, 12.5, 20, 25 |
|
|
|
|
|
| 704 x 288 | 1, 3, 5, 6, 12.5 |
|
|
|
|
|
| 704 x 576 | 1, 3, 5, 6 |
|
|
|
|
•Quality: Sets the picture quality of recorded video: LOWEST, LOW, STANDARD, HIGH, HIGHEST.
•Image Rate: Sets the image rate. Refer to Table B for more information.
•Prealarm: Specifies the amount of time the DVR stores video that was recorded before an alarm or motion event: OFF, 5 SEC, 10 SEC, 20 SEC, 30 SEC, 40 SEC, 50 SEC, 60 SEC.
•Postalarm: Specifies the amount of time that the DVR continues to record video after the alarm or motion event ends: OFF, 5 SEC, 10 SEC, 20 SEC, 30 SEC, 40 SEC, 50 SEC, 1 MIN, 2 MIN, 3 MIN, 5 MIN, 10 MIN.
To set up the normal recording mode:
1.From the Camera menu, click Normal Record.
2.Click the Channel box, and select the channel to configure.
3.Click the boxes to enter their settings.
4.Repeat steps 2 and 3 to configure the other channels.
5.Click Close.
6.Click OK.
30 | C4631M (11/09) |