Pelco Manual C490M-D (1/96) 3
Figure 1. HS1000 Dimension Drawing
4.1 CEILING MOUNTING (FLUSH)
To mount the enclosure to a wall/ceiling, perform the
following steps:
1. Open the front cover by removing the four (4) 1/4-
20 “Tampruf” screws. A special socket is provided
(fits 1/4-inch square drive). The cover hinges down.
2. Using the mounting bracket as a template, mark
and drill holes in the mounting surfaces.
3. Attach the enclosure with the required fasteners.
4. Route required cables through the back and/or top
of the enclosure.
5. Mount the camera/lens to the tilt table.
6. Make all appropriate connections (i.e., camera
power, video (coax), lens, speakers, infrared illu-
minators, heater/power kits).
7. Position the camera and tighten the 1/4-20 fasten-
ers to secure the tilt table in place.
8. Close the cover and check that all components clear.
Secure the cover with the four (4) 1/4-20 “Tampruf”
screws provided.