3.5 AUXILIARY FUNCTIONS
The Coaxitron® receiver, using a Revision J or newer receiver/driver PC board, is capable of operating up to four remotely activated auxiliary functions. Each auxil- iary output may be individually converted at the receiver for momentary or latching operation. Refer to Figure 4 to set jumpers for auxiliary functions. When in the latch- ing mode, activating the same AUX function will toggle the function from on to off.
The AUX outputs are buffered to provide a continuous 10 VDC at 25 mA to drive small relays, lamps or other external devices. Refer to Figures 5 and 6 for examples of typical circuits used for auxiliary functions.
Figure 5 shows a typical connection using the latching command to operate an external device for auto iris or manual iris operation (AUX 1 latches manual iris and AUX 2 latches auto iris.)
LATCHING
**FOR REVISION K (REV. K) BOARDS, SW1 POSITIONS ARE REVERSED; THAT IS, THE POSITION SHOWN ABOVE IS THE “LONG” POSITION FOR REV. K BOARDS.
AUXILIARY JUMPER
SETTINGS ON THE
COAXITRON® RECEIVER
BOARD. JUMPERS ARE
JP1 AUX1SHOWN IN THE MOMENTARY “POSITION” OR “MODE”.
JP2 AUX2
JP3 AUX3
JP4 AUX4
MOMENTARY
P 2 SW1 ** SHOWN IN THE
P 1 | “SHORT” POSITION |
| |
| BNC CONNECTORS |
| |
| CONNECTOR |
PC BOARD |
|
| POWER INPUT |
COAXITRON® RECEIVER
Figure 4. Jumper Settings on the Receiver/Driver PC Board
18 | Pelco Manual |
