Pelco C561M-F manual Output Wiring, Wiring Connector Diagram

OUTPUT WIRING

To install the output wiring to the camera, dome, or positioning system, refer to Figure 4 and do the following:

1.Refer to Table A and determine the output connection needed for your camera, dome, or positioning system. Refer to Figure 4, for the proper connector strip connections.

2.Attach one output wire to either the Tap A (24 VAC), Tap B (26 VAC), or Tap C (28 VAC) connections on the Secondary Output Tap’s connector strip and attach the second wire to the COM connection on the same strip. Be sure that you have the proper wiring size and distances installed if you plan to change connections later.

3.Close the lid to the WCS1-4 power supply, replace the retaining screw to the door latch, and then turn power on.

FUSE HOLDER

INPUT TERMINALS

GROUND STUD

SPARE FUSES

120V- F 1.6A H

240V- F 0.5A H

OUTPUT TERMINALS

Figure 4. Wiring Connector Diagram

6 C561M-F (8/06)