Pelco C1932M operation manual Cautions, CC3320 and CC4620 Cameras, Installation Instructions

CC3320 and CC4620 Cameras	Installation Instructions
	CAUTIONS

CAUTION

In order to avoid damaging your camera, note the following points.

1)The camera has threaded mounting points on the top and bottom of the case. Only use a standard, photographic mounting bolt with a 1/4-20 UNC thread.

2)Before fitting the lens, make sure that its back will not touch the CCD sensor or associated components when fully installed.

3)Do not touch the image surface of the sensor. If the sensor is accidentally touched, only clean it using isopropanol.

4)Do not expose the sensor to direct sunlight as this may impair the performance of the camera.

POWER SUPPLY

The CC3320 and CC4620 Series cameras are available in 230 VAC or 11-40 VDC/14-30 VAC low voltage types. The voltage required to operate the camera is clearly marked on the rear panel of the camera. The green POWER LED on the rear panel indicates that power is connected. Power the low voltage cameras only from a class 2 isolated power supply. The power consumption is less than 5 Watts.

230 VAC Power Supply

Cameras that are intended to operate directly from 230 VAC are fitted with a non-detachable power supply cord. The voltage of operation is clearly marked on the rear panel of the camera. Generally this is 230 VAC +10%/ -15% at 50 Hz. Refer to the wiring instruction label attached to the supply cord and terminate the cord with the appropriate circuit with a 3A fuse. CAMERAS MUST BE CONNECTED TO A PROTECTIVE EARTH GROUND. Ensure that a secure means of isolation from the AC power is provided for the camera in accordance with the national wiring regulations of the country of installation.

Auto-switching power supply

Cameras fitted with an automatic selecting power supply operate between 11-40 VDC and 14-30 VAC. Connections and polarity are indicated above the screw terminals on the rear panel. The power supply must be a class 2 isolated type.

VIDEO CONNECTIONS

To obtain a video output, connect a video coaxial cable terminated with a 75W BNC connector to the BNC socket marked VIDEO OUT on the rear of the camera.

Page4