Pelco CM9740-UPG-8312 INTRODUCTION

C1547M (7/03) 1

INTRODUCTION

The CM9740-UPG-8312 software upgrade kit provides the following items to upgrade System 9740™ software:

1System 9740 Setup Disk, version 3.74

1System 9740 Operation Disk, version 8.03.012

1System 9740 Utility Disk, version 8.03.012

1CM9740/9760 Resource CD-ROM, version 8.03.012

2U12 PROM (programmable read-only memory) chips, version 8.04, part number IC53-0042-0804

1 Chip extraction tool, part number ICPULLERTOOL

1 CM9740-CC1 System 9740 Controller Installation/Operation Manual, C1508M-A

1CM9760-MGR System Management Software Installation/Operation Manual, C547M-D

This manual provides an overview of the System 9740 software upgrade process and instructions for upgrading the software in

single-node and multi-node systems.

Contents

Main Page CONTENTS LIST OF ILLUSTRATIONS Page INTRODUCTION SOFTWARE UPGRADE OVERVIEW Upgrading System 9740 Software in a Single-Node System Upgrading System 9740 Software in a Multi-Node System. UPGRADING SYSTEM 9740 SOFTWARE IN A SINGLE-NODE SYSTEM filename do not use the same floppy disk that was used in step 4c. xxx filename Page UPGRADING SYSTEM 9740 SOFTWARE IN A MULTI-NODE SYSTEM filename do not use the same floppy disk that was used in step 1d(3). xxx filename Page s APPENDIX A. UPGRADING CM9740-MXB FIRMWARE Page Page APPENDIX B. CONNECTING AN ASCII COMMUNICATIONS DEVICE TO THE CM9740-CC1 Connecting an ACD DB9 Port to a CM9740-CC1 DB9 Port Connecting an ACD DB9 Port to a CM9740-CC1 RJ-45 Port CONNECTING AN ACD DB9 PORT TO A CM9740-CC1 DB9 PORT CONNECTING AN ACD DB9 PORT TO A CM9740-CC1 RJ-45 PORT PV130 C1547M (7/03) 15 WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico: REVISION HISTORY Manual # Date Comments C1547M 7/03 Original version.