4.Using the remaining six #4 sheet metal
5.Assemble both sets of front and rear mounting rails using three
6.Using six of the
7.Place the unit onto the mounting rails. It should slide in and out of the rack easily. This step may require two persons to lift and slide the unit into place.
8.Fasten the rack ears to the equipment rack using the four
FRONT MOUNTING RAIL
RACK
RECORDER/VIEWSTATION
| (8) SCREWS, | |
REAR MOUNTING RAIL | ||
FLAT HEAD | ||
|
(6) SCREWS,
PAN HEAD WITH LOCK WASHERS
(4) SCREWS,
BRACKET (SIDE VIEW)
(6) SCREW,#4, SHEET METAL, PAN HEAD,
PHILLIPS
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| TAPERED ENDS |
|
|
|
| SLOTTED HOLES |
|
| ||
|
|
| ||||
|
| TOWARDS FRONT | TOWARDS REAR | |||
|
| OF UNIT | OF UNIT |
Figure 6. Rack Mount Installation
NOTE: Pelco recommends at least one rack unit (1.75 inches or 4.44 cm) of spacing between units.
IMPORTANT: Slots and openings in the cabinet provide ventilation and prevent the unit from overheating. Do not block these openings. Never place the DVR near or over a radiator or heat register. Do not place it in a
7 |