Introduction
The information contained in the following sections will serve as an addendum to the DX8000 Installation manual. Each item within reflects either an addition or alteration to the original manual text. Please refer to these pages in place of the original manual text where applicable.
The following original document pages are affected.
Pages | Section |
11 | PARTS LIST |
EQUIPMENT RACK MOUNTING | |
34 | CONFIGURING THE LANGUAGE SETTING OF THE DX8000 |
NETWORK SOFTWARE CONFIGURATION | |
CLIENT SOFTWARE SETUP |
Additional Warnings and Cautions
IMPORTANT: Read and keep all instructions, including the accompanying security and safety information documents.
CAUTION: The recorder should be installed in an air conditioned room where the temperature is maintained between 50° and 90° F (10° and 35°C) with relative humidity not to exceed 80 percent, non condensing.
WARNING: All operating system files, applications, and utilities necessary to operate the DX8000 have been preinstalled on the unit. Do not install or use any software, including antivirus utilities, on the DX8000 Series DVR other than those that have been installed at the factory.
WARNING: Do not install any additional hardware on the DX8000 Series DVR other than those devices listed in the documentation accompanying the unit. Do not remove, replace, or change any existing hardware in the DX8000 Series DVR without first consulting Pelco technical support or an authorized Pelco service center.
IMPORTANT: When using the networking capabilities of the DX8000, Pelco recommends that each DX8000 Series DVR be connected to a secure, private network. Do not directly connect your DVR to a public network such as the Internet.
It is recommended that the recorder be connected to an uninterruptible power supply (UPS) capable of supplying 2A for 120 VAC power systems or 1A for 230 VAC power systems.
4 |
