Pelco es3012 4, 5, 6, 7

10 Pelco Manual C306M-K (4/05)

4Route the wires and cables through

the center of the Esprit mount. Re-

install the transformer module into

the base. The transformer module

can be positioned in the mount

base in only one orientation.

5ES3012-5 Model Only – Set the 120/230 voltage selector switch on the trans-

former to the appropriate voltage.

6Connect wires and cables.

a. Connect to power. Use the two supplied clamp connectors to connect the AC line

and neutral.

120/230 VAC 24 VAC

Black wire Input (AC Line) White wire Input (AC Line)

White wire AC Neutral White wire AC Neutral

Green wire Ground Green wire Ground

b. Connect the video coaxial cable to the BNC connector.

c. Connect the wiring for a two-wire or four-wire control system. This step does not

apply to Coaxitron® control systems.

Green wire RX-

Red wire RX+

Black wire TX-

White wire TX+

7Install mount; refer to the installation manual supplied with the mount for instructions.

120/230 VOLTAGE

SELECTOR SWITCH

Contents

Main Page Pelco Manual C306M-K (4/05) 3 CONTENTS Page Pelco Manual C306M-K (4/05) 5 IMPORTANT SAFETY INSTRUCTIONS 6 Pelco Manual C306M-K (4/05) DESCRIPTION MODELS INSTALLATION CAMERA AND LENS INSTALLATION Pan and Tilt Installation A B C 3 4 5 PAN AND TILT INSTALLATION 1 2 3 The illustrations show the ES3012 Esprit mounted to an EWM wall mount. 4 5 6 7 8 9 10 Page HOW TO REINSTALL THE PAN AND TILT COVER OPERATION POWER-UP DISPLAY Operating Notes Programming Power-Up Mode in the Programming PAN, SCAN, AND TILT SPEEDS LENS FUNCTIONS PRESET FUNCTIONS RANDOM, FRAME, AND AUTO SCANNING ZONES PROGRAMMING ESPRIT MENUS PRESETS ACCESSING MAIN MENU (PRESET 95) if this is your first time entering this mode AZ/EL Az/El display is not available while you are AZ/EL LINE Az/El display is not available while you are AZIMUTH ZERO DIRECTION For direction to be accurate, the azimuth zero must be set to magnetic north. Direction display is not available while you are programmming or running a DIRECTION LINE Direction display is not available while you are DISPLAY DURATION LIMIT STOPS TURNING LIMIT STOPS ON OR OFF PROGRAMMING LIMIT STOPS Manual Limit Stops Scan Limit Stops PAN/SCAN SPEED PARK TIME NOTE: CAUTION: PATTERN LENGTH POWER-UP MODE SPEED PROFILE ZONES ZONE BLANK 30 Pelco Manual C306M-K (4/05) TROUBLESHOOTING MAINTENANCE Troubleshooting Warranty and Return Information 32 Pelco Manual C306M-K (4/05) APPENDIX Esprit will sense and automatically select input from Coaxitron Table A. Switch Settings for SW1 NOTES: Pelco Manual C306M-K (4/05) 33 Table B. Switch Settings for SW2 (Continued on next page) NOTE: 34 Pelco Manual C306M-K (4/05) Table B. Switch Settings for SW2 (continued) (Continued on next page) Pelco Manual C306M-K (4/05) 35 Table B. Switch Settings for SW2 (continued) SPECIFICATIONS (Design and product specifications subject to change without notice.) Pelco Manual C306M-K (4/05) 37 Figure 1. Esprit ES3012 System Dimensions Drawing REGULATORY NOTICES REVISION HISTORY Product Warranty and Return Information. section. In March, removed wiper material from Troubleshooting Trouble- shooting