18 Pelco Manual C306M-K (4/05)
AZ/EL
Other Menu
Park Time 0
Pan/Scan Spd 7
Power Up Default
Pat length 6 min
Spd Profile 50 MPH wind
<Zone Blank>
<Az/El/Direction>
Exit
Az/El/Direction
Set Azimuth Zero
Az/El
Az/El Line
Direction
Direction Line
Disp Duration
Exit
Az/El programs the horizontal display position of the Azimuth1/Elevation2 label.
The following settings are available for the Az/El label:
Off – Label is not displayed.
Left (default) – Label is displayed on the left-hand side of the screen.
Center – Label is displayed in the center of the screen.
Right – Label is displayed on the right-hand side of the screen.
To program the horizontal label position for Az/El:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Other.
3. Press the Iris Open button to enter the Other menu.
4. Position the cursor (>) beside Az/El/Direction.
5. Press the Iris Open button to enter the Az/El/Direction menu.
6. Position the cursor (>) beside Az/El.
7. Press the Iris Open button. The cursor moves to the right.
8. Move the joystick up or down to view the available selections.
9. SELECT – Press the Iris Open button to make a selection.
CANCEL – Press the Iris Close button to cancel selection.
1 Azimuth is the pan angle from 0° to 359°.
2 Elevation is the tilt position from 33° to -83°.
MAIN MENU
<Limit Stop>
<Other>
EXIT
NOTE:

Az/El display is not

available while you are

programming or running a
pattern.