If the camera will use a different voltage than the enclosure’s heater perform the following steps.
1.Bring in wires for AC high and AC neutral. If you are using 24 VAC, refer to Table A. Connect the wires as follows: Connect AC high to connector 9 of the
Connect AC neutral to connector 10 of the
2.Connect the leads from the
Brown | AC HI |
Blue | AC NT |
Refer to Figures 1 and 2 and connect the plug to the CAM 2 socket on the circuit board.
FINAL INSTALLATION
1.Adjust the focus and iris on the camera, if necessary.
2.Reassemble the top and bottom enclosure sections.
3.Install and tighten the four
4.If the enclosure is installed outdoors and has watertight fittings installed on the bottom of the enclosure, be sure the fittings have been tightened enough to prevent water from getting inside the enclosure.
11 |