Pelco ICS210 Installation

6 C2491M-C (1/06)
Installation
PREPARE MOUNTING SURFACE
1. Remove the cover of the ICS210. Use the screwdriver bit that is provided to loosen the
three tamperproof screws, and then lift the cover from the base.
2. Remove the camera assembly from the base by removing the Phillips screws on each
side of the camera assembly (refer to Figure 2).
Figure 2. Removing Camera Module
3. Remove the base from the mounting plate by removing the three 8-32 x 0.375-inch
screws and lock washers. Lift the base from the mounting plate and set the base,
screws, and lock washers to the side.
CAMERA ASSEMBLY
PHILLIPS
SCREW