Pelco ips-rdpe-2 manual The maximum wire gauge allowed for UTP is 16 AWG

PTZ CONTROL AND SOFTWARE UPLOAD

POSITIONING SYSTEM		VC-UTP
POWER
TX+	TX- RX+ RX-	UTP- UTP+

IPS-RDPE-2
									RX- RX+ TX- TX+	UTP- UTP+
					RX- RX+ TX- TX+					UTP- UTP+
				VAC+	VAC-	VAC+	VAC-	TO
				24	24	24	24	POWER
								SUPPLY
POSITIONING SYSTEM				VC-UTP
POWER									TX- TX+ RX- RX+
TX+	TX- RX+ RX-			UTP- UTP+				CONTROL SYSTEM		UTP- UTP+
										UTP RECEIVER
										AT CONTROL SYSTEM
PTZ CONTROL AND
SOFTWARE UPLOAD
IPS-RDPE-2										UTP- UTP+
										UTP RECEIVER
										AT CONTROL SYSTEM
RX- RX+ TX-			TX+	RX- RX+ TX-		TX+		UTP- UTP+	UTP- UTP+
VAC+	VAC-	VAC+	VAC-	TO
24	24	24	24	POWER
				SUPPLY

Figure 11. RS-422 (D or P Protocol) Controller with UTP Video – Daisy-Chain Configuration

NOTES:

•Input power for the IPS-RDPE-2 is 24 VAC only. The maximum wire gauge allowed for power input and output is 12 AWG.

•The maximum wire gauge allowed for UTP is 16 AWG.

•Refer to the manual supplied with the positioning system for wiring distances and coaxial cable requirements.

16 C2473M-C (8/06)