Pelco PMC09A Series operation manual FCC & Ices Information, Safety Precautions

FCC & ICES INFORMATION

(U.S.A. and Canadian Models Only)

WARNING - This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of Industry Canada. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment gener- ates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter- ference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is en- couraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Intentional or unintentional changes or modifications not expressly ap- proved by the party responsible for compliance shall not be made. Any such changes or modifications could void the user’s authority to operate the equipment.

The user may find the following booklet prepared by the Federal Commu- nications Commission helpful: “How to Identify and Resolve Radio-TV In- terference Problems”. This booklet is available from the U.S. Government Printing Office, Washington, DC 20402, Stock No.004-000-00345-4.

Safety Precautions

CAUTION

RISK OF ELECTRIC SHOCK.

DO NOT OPEN!

CAUTION: TO REDUCE THE RISK OF ELECTRI- CAL SHOCK, DO NOT OPEN COVERS. NO USER SERVICEABLE PARTS INSIDE. REFER SERVIC- ING TO QUALIFIED SERVICE PERSONNEL.

This label may appear on the bottom of the unit due to space limitations.

The lightning flash with an arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is in- tended to alert the user to presence of important operat- ing and maintenance (servicing) instructions in the litera- ture accompanying the appliance.

Warning

To prevent fire or shock hazard, do not expose units not spe- cifically designed for outdoor use to rain or moisture.

Attention: Installation should be performed by qualified service personnel only in accordance with the National Electrical Code or applicable local codes.

Power Disconnect.Units with or without ON-OFF switches have power supplied to the unit whenever the power cord is inserted into the power source; however, the unit is operational only when the ON-OFF switch is in the ON position. The power cord is the main power disconnect for all units.

Improper Operation. Alteration of the high voltage circuit or changing the display tube type may result in an increase in the x-ray emission of this unit. A unit altered in such a way no longer meets the standards of certification and must no longer be operated.

WARNING: Electrostatic-sensitive device. Use proper CMOS/MOSFET handling precautions to avoid electrostatic discharge.

NOTE: Grounded wrist straps must be worn and proper ESD safety precautions observed when handling the electrostatic-sensitive printed cir- cuit boards.

3