Pelco PMM15A, PMM20A, PMM12A manual Description, Installation, Models, Mounting, Connections

DESCRIPTION

The PMM9A, PMM12A, PMM15A, and PMM20A are high resolution, black and white, CCTV video monitors. The cabinets are made of steel for ruggedness and, with the exception of the picture tube, the circuitry is all solid-state for reliability.

MODELS

PMM9A	Black and white monitor, 9-inch (22.86 cm) picture display, 96-256 VAC, 50/60 Hz, EIA/CCIR, auto-sensing
PMM12A	Same as PMM9A except 12-inch (30.48 cm) picture display
PMM15A	Same as PMM9A except 15-inch (38.10 cm) picture display
PMM20A	Same as PMM9A except 20-inch (50.80 cm) picture display

INSTALLATION

The following parts are supplied:

Monitor

Two power cords (1 USA standard and 1 European standard)

MOUNTING

The monitor has rubber feet and may be placed on any horizontal surface, such as a desk or table. The monitor also can be mounted to a wall or ceiling with an appropriate mount. If you have a PMM9A, PMM12A, or PMM15A monitor, it can be installed in a 19-inch equipment rack with a suitable rack-mounting kit. For mounting to a wall or ceiling or in a rack, refer to the instructions with the mount.

CONNECTIONS

SINGLE-MONITOR INSTALLATION

Refer to Figure 1 and Table A for the following instructions.

1.Set the impedance switch on the back of the monitor to LO (75 ohms).

2.Connect a 75-ohm video cable from the video source, such as a camera, to the BNC connector labeled VIDEO IN (or INPUT) on the back of the monitor.

3.Plug in the appropriate power cord.

Figure 1. Singe-Monitor

Installation (PMM15A Shown)

6 C2902M (10/02)