30 Pelco Manual C671M (1/01)
FIRST TIME SET UP MENU
NOTE:
Quasi v-sync must
be set OFF for some multi-
plexers to work properly.
With the Pelco MX4000
Series Genex Multiplexer,
setting quasi v-sync on or
off has no apparent effect
on playback.
NOTE:
To stop the buzzer,
press the MENU button
once. If the Main menu ap-
pears, press MENU again to
exit the menu. When the
VCR is locked, press the
LOCK button to unlock the
VCR; then the buzzer stops.
<FIRST TIME SET
U
TIME DATE ADJUS
T
TAPE END
QUASI V-SYNC
VIDEO MODE
TAPE LENGTH
BUZZER
Figure 18. First Time Set
Up Menu
TIME DATE ADJUST Sets the time, date, and daylight saving time setting. Refer to the
Set the Day and Time
section for the procedure.
TAPE END Sets the VCR’s state of operation when the tape runs out during
recording, as follows:
•STOP – The tape stops. “End” appears on the fluorescent
display and TAPE END on the monitor. When CALL OUT is
set to WRNG•TAPE END, a call signal is output from the
CALL OUT terminal.
•REWIND – Rewinds the tape to the beginning and stops
(except during timer recording). When CALL OUT is set to
WRNG•TAPE END and a tape reaches its end, a call signal
is output for two seconds from the CALL OUT terminal.
• REPEAT – Rewinds the tape to the beginning and resumes
recording. When CALL OUT is set to WRNG•TAPE END and
a tape reaches its end, a call signal is output for two seconds
from the CALL OUT terminal.
•ALARM•PROT – (Alarm Protection) If alarm recordings are
on the tape and the tape stops, “End” appears on the
fluorescent display and TAPE END on the monitor. When
CALL OUT is set to WRNG•TAPE END, a call signal is
output from the CALL OUT terminal. If there are no alarm
recordings, the tape rewinds and recording continues.
QUASI V-SYNC Sets quasi v-sync on or off.
•ON – Quasi v-sync signal is inserted on the video output
signal when in the special playback modes (still, slow
motion, reverse, fast playback, and speed search) and
during playback in L24H and L40H modes.
• OFF – Quasi v-sync signal is not inserted.
VIDEO MODE Sets the playback and recording color mode.
•AUTO – The VCR automatically switches the circuits
according to the type of input/playback video signal; color, or
black and white.
•B/W – Select for recording or playback in black and white.
•COLOR – Select for recording or playback in color.
TAPE LENGTH Sets the tape length.
•T-120 – Select when using T-120 tape.
•T-160 – Select when using T-160 tape.
BUZZER Sets a buzzer to sound a warning.
•WRNG – The buzzer sounds when the VCR malfunctions.
•WRNG•TAPE END – The buzzer sounds when the VCR
malfunctions or the tape reaches its end.
•WRNG•REMAIN – The buzzer sounds when the VCR
malfunctions or the tape has about nine minutes left (in 8H
mode).
•OFF – The buzzer does not sound.