YOU WILL NEED TO SUPPLY:
ss#EDAREOR )MPERVIOUSOSHIMSSPACERSMTO ss GALVANIZED ROOlNGlNAILS LB
ssX CORROSIONIRESISTANT mAT HEAD WOOD SCREWS OR equivalent screws for concrete applications
ss#LOSED CELLEFOAM BACKERLRODSEALANT BACKERN TO CFT
ss0ELLA® SmartFlash™ foil backed butyl window and door flashing tape or equivalent
ss(IGHGQUALITYUEXTERIOR GRADE POLYURETHANE ORNSILICONE
sealant (1 tube per window) | SEALANT |
ss'REATA3TUFF ™ Window and Door Insulating Foam Sealant by the Dow Chemical Company or equivalent low pressure polyurethane window and door foam
-DO NOT use high pressure or latex foams ss)NTERIORRTRIM ANDORRJAMB EXTENSIONSO TO MFT
INSTALLATION CLIP OPTION:
ss OR )NSTALLATIONLCLIP
ss X XCORROSIONIRESISTANT mAT HEAD WOOD SCREW ss X CORROSIONIRESISTANT mAT HEAD OR X
TOOLS REQUIRED: ss4APEPMEASURE ss,EVEL ss3QUARE ss(AMMER ss3TAPLER ss3EALANT GUN ss3CISSORS ORSUTILITY KNIFE ss3TIFF PUTTY KNIFE ss0HILLIPSLSCREWDRIVER ss$RILL ss$RILL BITS AND
REMEMBER TO USE APPROPRIATE PERSONAL PROTECTIVE EQUIPMENT.
1 ROUGH OPENING PREPARATION
A. Verify the opening is plumb and level. | Interior | |
Note: It is critical that the bottom is level. | ||
| ||
B. Verify the window will fit the opening. | 1A | |
|
Measure all four sides of the opening to make sure it is 1/2" larger than the window in both width and height. On larger openings measure the width and height in several places to ensure the header or studs are not bowed.
Note:
Interior
1B
C.Cut the water resistive barrier (1C).
D.Fold the water resistive barrier (1D). Fold side flaps into the opening and staple to inside wall. Fold top flap up and temporarily fasten with flashing tape.
Water Resistive Barrier
1st cut
3rd cut
1C
2nd
cut
4th cut:
Make a 6" cut up from each top corner at a 45°
angle to allow the water resistive barrier to be lapped over the fin at the head of the window.
Exterior
1D
E.Apply sill flashing tape #1. Cut a piece of flashing tape 12" longer than the opening width. Apply at the bottom of the opening as shown (1E) so it overhangs 1" to the exterior.
Note: The tape is cut 12" longer than the width so that it will extend 6" up each side of the opening.
F.Tab the sill flashing tape and fold. Cut 1" wide tabs at each corner (1/2" from each side of corner) (1F). Fold tape to the exterior and press firmly to adhere it to the water resistive barrier.
1" |
1E |
6" |
1/2" |
1/2" |
1F |