Pella 80ED0101 installation instructions Installation Clip Method, Plumb and square window

B.Plumb and square window.

Frame screw method: Place shims 1" from the bottom and top of the window between the window and the sides of the opening. Adjust the shims as required to plumb and square the window in the opening. Place shims at the midpoint of the window sides. Adjust the shims until the window sides are straight, and

the space between the sash and frame is equal from top to bottom.

Installation clip method: Shim between the installation clip and the rough opening at each clip location.

3B

INTERIOR

3B

Note: DO NOT shim above the window or in the space between the spacers at the bottom of the window. DO NOT over shim.

C. Check the interior reveal. Make sure the measurement from the interior	3C
face of the window to the interior face of the wall is equal at several points
	mm2	1 INCHES		2
around the window.	0	30	40			70
				50	60

Note: If the dimensions are not equal, check to make sure the fins are folded out to 90° at all points.

3

D. Fasten the window to opening BYYDRIVINGI GALVANIZED ROOlNGlNAILS into each pre-punched hole in the nailing fin.

Note: Make sure the fin corner is lying as flat as possible.

E.Check window operation (vent windows only). Cut the checkrail bands and remove the shipping spacers. Open and close the window a few times to check for proper operation. Make sure the window will tilt correctly.

Note: If there are any problems with the operation of the window, recheck shim locations and adjust for plumb and square.

Note: If installing the window using frame screws, proceed to Step 5 - FRAME SCREW METHOD.

3D

INTERIOR

4 INSTALLATION CLIP METHOD

4A

A.Fasten the window to the opening BYYDRIVINGITWOI X OCORROSIONI resistant screws into the pre-punched holes in the clips. If clips are bent and fastened to the interior stud/block, install the screws as close to the bend as possible.

Note: DO NOT shim above the window. For masonry openings use two 3/16" x 1-1/2" masonry screws per clip. Pre-drill the masonry before attempting to drive the screws in.

B. Simulated-hung only: Remove the
	4B

simulated-hung lock by removing the four screws from each lock.

INTERIOR

C.Raise the lower sash.

D.From the room side of the window, drill

 DIAMETERDCLEARANCETHOLES THROUGH THE sill of the frame. Space the holes as shown.

E.Fasten the sill to the opening BYYDRIVINGII XX CORROSIONIRESISTANT TmATNHEAD WOODASCREWS into each of the pre-drilled clearance holes.

Note: Drive the screws until snug but DO NOT over-tighten them. DO NOT bend or bow the unit frame.

F.Simulated-hung only: Close the lower sash and reinstall the lock(s).

#10 x 3"	4E
stainless steel
flat head
wood screw
Drill 13/64”	4D
diameter clearance
hole.
SILL

	4C
6“	CENTER	6“

Note: Arrows indicate the placement of clearance holes.