Pella 80JJ0103 installation instructions Rough Opening Preparation, flashing tape or equivalent

YOU WILL NEED TO SUPPLY:

ss#EDAREOR )MPERVIOUSOSHIMSSPACERSMTO  ss GALVANIZED ROOlNGlNAILS  LB ss D NAIL ss#LOSED CELLEFOAM BACKERLRODSEALANT BACKERN TO CFT

ss0ELLA® SmartFlash™ foil backed butyl window and door
flashing tape or equivalent
ss(IGHGQUALITYUEXTERIOR GRADE POLYURETHANE ORNSILICONE
SEALANTL TOT TUBES PERODOOR	4&"-"/5

ss'REATA3TUFF ™ Window and Door Insulating Foam Sealant by the Dow Chemical Company or equivalent low pressure polyurethane window and door foam - DO

./44USEUHIGH PRESSUREEOR LATEX FOAMS

ss0ELLA ALUMINUMLSILL SUPPORTTOR  X  WOODXBLOCKING ss)NTERIORRTRIM ANDORRJAMB EXTENSIONSO TO MFT

TOOLS REQUIRED:

ss4APEPMEASURE ss,EVEL

ss3QUARE

ss(AMMER ss3TAPLER ss3CISSORS ORSUTILITY KNIFE

ss3CREWDRIVERSR

 0HILLIPSLANDPSMALLAmATDBLADE

ss !LLEN WRENCH ss$RILL ss3EALANT GUN

REMEMBER TO USE APPROPRIATE PERSONAL PROTECTIVE EQUIPMENT.

1ROUGH OPENING PREPARATION

A.Verify the opening is plumb and level. Note: It is critical that the bottom is level.

*OUFSJPS

B.Verify the door will fit the opening. Measure all four sides of the opening to make sure it is 3/4" larger than the door in width and 1/2" larger in height. On larger openings measure the width and height in several places to ensure the header or studs are not bowed.

Note: 1-1/2" or more of solid wood blocking is required around the perimeter of the opening. Fix any problems with the rough opening before proceeding.

£

*OUFSJPS

C. Cut the water resistive barrier.

BUFS
3FTJTUJWF
#BSSJFS TU
DVU

		SE DVU
		UI DVU
		.BLF B  DVU VQ GSPN
		FBDI UPQ DPSOFS BU B ¡
		BOHMF UP BMMPX UIF XBUFS
		SFTJTUJWF CBSSJFS UP CF
	OE	MBQQFE PWFS UIF mO BU UIF
£		IFBE PG UIF EPPS
	DVU

£

&YUFSJPS

£

D. Fold the water resistive barrier (1D). Fold side flaps into the opening and staple to inside wall. Fold top flap up and temporarily fasten with flashing tape.