L.Check door operation. Open and close the door to check for proper operation. Make sure the door will latch correctly.
Note: If there are any problems with the operation, recheck and adjust the reveal.
M.Adjust the reveal if needed. The door panels have adjustable hinge
LEAFS 5SING A AALLENWRENCH TURN THEUCENTER SCREWWCLOCKWISEETO |
| |
increase the space between the hinge side of the frame and the door |
| |
panel, or counter clockwise to increase the space between the door |
| |
panel and the lock side of the frame. DO NOT turn the screws more |
| |
than a 3/4 turn in either direction. In some cases it may be necessary |
| |
to loosen and then tighten the top and bottom hinge screws to obtain |
| |
full hinge adjustment. If necessary, loosen the top and bottom screws, |
| |
and immediately retighten them. With the screws retightened, turn the |
| |
adjustment hinge screw. If the hinge will not adjust any further then |
| |
it is adjusted as far as it will go. If more clearance is needed adjust the | Ó | |
shims between the frame and the rough opening. | ||
| ||
Note: DO NOT adjust the hinge with the top and bottom screws |
| |
loose; this could force the hinge to adjust beyond its design capability | Ó | |
which can cause the hinge to bind, damage the hinge and/or pull out |
| |
the screws. A 3/4 turn of the center screw provides approximately |
| |
1/16" adjustment. |
| |
N. On doors with a lock strike in the side, DRILL A DIAMETER X DEEP |
| |
PILOTLHOLE THROUGH THE LOCKHSTRIKE AND INTOSTHERROUGH OPENINGP)NSERTTA X |
| |
SCREWWPROVIDED INTO THEIPILOTOHOLE MAKINGPSUREETHAT ITAPASSESETHROUGH THE |
| |
shim and into the stud. |
| |
Note: This step does not apply to center latching double doors. |
|
O. Install a #8 x 3" flat head stainless steel screw INTONTHEOHOLE LOCATED APPROXIMATELY FROM THE TOP OF THEODOOR FRAME TON THE LATCH SIDEFOF THE FRAME
3INTEGRATING THE DOOR TO THE WATER RESISTIVE BARRIER
Note: The flashing tape must be applied approximately 1/2" onto the frame cladding at the jambs and head.
A. Apply side flashing tape. Cut two pieces of flashing tape 4" longer than the frame height of the door. Apply one piece 1/2" onto the frame cladding, OVER THE NAILING lNAANDLONTO THE WATER resistive barrier on each side. The tape
SHOULD EXTEND ABOVEETHETTOPEOF THE
door and 2" below the bottom of the |
|
DOOR0RESSSTHE TAPE DOWN lRMLY WHILE |
|
FOLDINGDDOWN THE EXCESS TAPE AT THE TOP |
|
and bottom of the door. | Î |
