Pella 80YW0102 warranty Sealing And Fastening The Window

" /*/(

$"4&.&/5

D.Remove Interior Frame Cover #3.

The cover on vent units on the opposite frame side from where the crank handle is located.

For Standard Awning greater than 42" in width, single units greater than 42" in height and multiple window combinations.

 6WDUWDWRQHHQGRIWKHFRYHUDQGLQVHUWWKHWRROEHWZHHQ the frame and cover as shown.

 3XOOWKHWRRODZD\IURPWKHIUDPHWRVWDUWUHOHDVLQJWKH cover barbs from the frame kerfs.

 :KHQWKHFRYHUEHJLQVWRSXOODZD\IURPWKHIUDPHJUDVS the cover and continue to pull to release the barbs from the kerfs, removing the cover.

%

TWO OR MORE PEOPLE ARE REQUIRED FOR THE FOLLOWING STEPS

4 SEALING AND FASTENING THE WINDOW

A.If the existing double-hung has a sloped sill, the sill of the new window will need to be supported by using the Pella replacement sill adapter accessory or by using wood blocking as needed.

B.If using the Pella replacement sill adapter accessory:

Dry fit the window, temporarily fasten or with someone holding it in place, confirm the window will fit. From the exterior, measure the distance from the bottom of the window to the existing sill.

 ,IRU!QRDGMXVWPHQWWRWKHVLOODGDSWHU is needed.

,IWREUHDNRIIDWWKHŵUVWVFRUHPDUN

,IWREUHDNRIIDWWKHVHFRQGVFRUH mark.

5HPRYHWKHZLQGRZIURPWKHRSHQLQJ0HDVXUH the width of the window and cut the sill adapter to the same length. Apply the sill adapter by sliding it into the fin groove.

$BTFNFOU 4JMM
.FBTVSF
UIJT
EJTUBODF
#	4*-- $65" ": 7*&

C. Apply a 3/8" bead of sealant at the point where	%
the existing stool meets the existing window sill.
Additionally, place sealant at the ends of the flashing	$
tape, making sure to connect with the stool sealant.

D. Apply a continuous 3/8" diameter bead of sealant at the exterior surface of the interior head and jamb stops. Connect this bead of sealant to the sealant line on the stool.

E. Insert the replacement window in the opening. Check to make sure the window rests against the interior blind stops and is making contact with the sealant.

F.From the exterior, place shims near the top of one jamb, in line with the top pre-drilled

KROHLQWKHZLQGRZIUDPH3DUWLDOO\LQVHUWRQHZRRGVFUHZ5HSHDWWKHSURFHVVIRU the other jamb.

Note: Position shims to ensure they allow at least 1/2" from the exterior surface of the window to allow for placement of backer rod and sealant.

G.Casement Units Only -,IDGGLWLRQDOLQVWDOODWLRQKROHVDUHQHHGHG GULOODŔLQVWDOODWLRQKROHWKURXJKERWKWKHLQWHULRUDQGH[WHULRU walls of the frame.

Exterior

3/16”

3/16”

Casement