EXTERIOR FINISH OF EXISTING FRAME
The exposed wood and flashing tape on the exterior stop needs to be covered/protected. There are many ways to accomplish this, and each case can be unique.
$IHZSRVVLELOLWLHVLQFOXGH
D &RYHULQJWKHH[LVWLQJWULPZLWKDOXPLQXPFRLOZUDS frame expander.
E 6DQGLQJSULPLQJDQGSDLQWLQJWRPDWFKH[LVWLQJWULP
F &RYHULQJWKHH[SRVHGZRRGZLWKDKLJKTXDOLW\H[WHULRU grade sealant.
Note: The contractor/installer will determine how to finish the exterior.
&95&3*030' */%0 |
*5)'3".&&91"/%&3 |
AWNING AND CASEMENT ONLY
" /*/( |
$"4&.&/5 |
INSTALLING ROTO COVER AND CRANK
A.Place the cover over the operator stud and snap into place.
B.Apply pressure to the pocket end of the cover and snap into place.
1PDLFU&OE #
& 8VHDPHGLXPVL]HŶDWEODGHVFUHZGULYHUWR loosen the set screw in the crank handle.
"
0QFSBUPS4UVE
' 6OLGHWKHFUDQNKDQGOHRQWRWKHVWXG8QORFN open window, then close and lock window.
E.Fold the crank handle down and check alignment of knob with the pocket.
Note: You may need to adjust the crank position on the stud until the correct alignment is achieved.
F.Open the crank and tighten the set screw.
G.After the final installation, fold the crank over and snap the knob into the pocket.
Note: Even with the window open the crank can be folded to avoid interfering with the window treatments.
$SBOL)BOEMF %
0QFSBUPS4UVE
| 4FU4DSFX | $ |
|
| |
,OPC |
| & |
| 1PDLFU |
|
