Pentair AmerQuartz important safety instructions Transformer required on 12 volt models

WARNING

Replace the lamp with a similar type and wattage. Failure to replace the lamp with the same type of lamp will damage the light assembly and may cause an electrical hazard resulting in death or serious injury to pool users, installers, or others due to electrical shock, and may also cause damage to property.

WARNING

Always install a new lens gasket (part number 79101601) whenever disassembling the light. Failure to do so may permit water to leak into the assembly which could cause:

(a)an electrical hazard resulting in death or serious injury to pool users, installers, or others due to electrical shock., or

(b)breakage of the lamp or lens, which likewise could result in serious injury to pool users, installers, or bystanders, or in damage to property.

3.Toremovelightassembly,removethespecialpilotscrewattopoffacering,removelightassemblyfromniche,and place assembly on deck.

WARNING

Be sure to keep the special pilot screw from this underwater light. This screw mounts and electrically grounds the housing securely to the mounting ring and wet niche. Failure to use the screw provided could create an electrical hazard which could result in death or serious injury to pool users, installers or others due to electrical shock.

NOTE

Transformer required on 12 volt models.

4.Disassemblelightfixtureandremovebulb.

a.For double-ended bulbs, push bulb towards spring loaded socket. When the other end of the bulb is clear of the fixed socket, pivot the bulb out of the fixed socket and remove bulb, see Figure 2.

b.For 2 pin bulbs, pull bulb straight out of the socket. When replacing the bulbs in the 12-volt lights, ALWAYS replace both bulbs at the same time, see Figure 2.

WARNING

Be sure the power is OFF before installing or removing lamp. Allow the lamp to cool before relamping. This light fixture uses a Quartz Halogen lamp. DO NOT touch the lamp with bare hands: This may severely reduce its life. Use the plastic furnished with the replacement, a clean rag, or a tissue to eliminate fingerprints from getting on the lamp.

5.Installthenewlamp(s).

6.Remove old gasket from lens and discard it.

7.Install new gasket during reassembly of light, Pentair Water Pool and Spa part number 79101600.

WARNING

Never operate the underwater light for more than 10 seconds unless it is totally submerged in water. Without total submersion, the light assembly will get extremely hot and may result in serious burns or in breakage of the lamp or lens. This may result in serious injury to pool users, installers, or bystanders, or in damage to property.

8.Secure ring to light fixture. See Section IV, Stainless Steel Face RingAssemblyInstructions.

9.Replacelightassemblyintonicheandtightenspecialpilotscrew.

120volt,Double-ended,TypeT-3R7S

12 volt, 2 Pin, Type T-3 GY 6.35 Figure2.

P/N • Núm/Pte. • Réf. 99101600 6 Rev. D • Rev. D • Rév. D 10-29-07