Pentair Save These Instructions, Section V. AmerQuartz Replacement Parts

45 degrees

Withthelightrestingonitsbase,placethegasketassembly on top of the light shell as shown, see Figure 4. A NEW

LENS GASKET MUST BE USED EACH TIME THEBolt and nut are to be tightened at approx. 45 degrees from the pilot screw between the tabs on the face ring

LIGHT IS REASSEMBLED. Center the stainless steelas shown above. face ring and place it over the lens and gasket assembly.

Thelockingleversshouldallbehangingfreelydowntoinstalloverthelensandgasket.Alignthespecialpilotscrew onthefaceringwiththeletter"R"oftheword"Before"asusedinthephrase"SUBMERGE BEFORE LIGHTING" found on the lens surface and the compression fitting on the light shell, see Figure 1.

WARNING

Use only the special pilot screw provided with this underwater light. This screw mounts and electrically grounds the housing securely to the mounting ring and wet niche. Failure to use the screw provided could create an electrical hazard which could result in death or serious injury to pool users, installers or others due to electrical shock.

10.Fillpooluntiltheunderwaterlightiscompletelysubmerged in water before operating the light for more than 10 seconds. Turn on main switch or circuit breaker, as well as the switch which operates the underwater light itself, to check for proper operation.

Section IV. Stainless Steel Face Ring Assy. Instructions

1.

Figure3.

Figure4.

A

2.Withthebentendsofthecircularuni-tensionclamppointingdownspreadtheclampandplaceitinthe“U”recesses of the locking levers. Be sure the bent ends of the clamp are located between the pair of locking levers as shown in Figure 3, location A. Check to see that the clamp is properly engaged with all of the levers.

3.Turnthelightsothatitisnowrestingonitslens.Tightenthescrewandnutuntilthedistancebetweentheendsofthe clamp equals 1/4 inch or less; see Figure 4.

Section V. AmerQuartz Replacement Parts

1

2

3

4

5

6

7

Item	Part
No.	No.	Description

179212100 Face ring, large plastic, white

179212165 Face ring, large plastic, gray

179212111 Face ring, large plastic, black

279104800 Pilot Screw, with captive gum washer, brass

2 619355 Pilot Screw, with captive gum washer, S/S

379110600 Face ring assembly, S/S

479111000 Uni-tension wire clamp assy.

579100100 Lens, clear, 8-3/8 in. dia., tempered

679101601 Gasket, 8-3/8 in. lens

779131000 Bulb, 300 watt, 120 volt, double-ended T3 R7S

779131100 Bulb, 500 watt, 120 volt, double-ended T3 R7S

779131400 Bulb, 50 watt, 12 volt, 2 Pin T3 GY 6.35, 2 req.

779131200 Bulb, 100 watt, 12 volt, 2 Pin T3 GY 6.35, 2 req.

78900700 Kwik-change lens cover, green

78900800 Kwik-change lens cover, blue

78900900 Kwik-change lens cover, red

78901000 Kwik-change lens cover, amber

SAVE THESE INSTRUCTIONS

Rev. D • Rev. D • Rév. D 10-29-07 7 P/N • Núm/Pte. • Réf. 99101600