5.Remove
a.Press safety latch (below the ring) toward the tank to release it (see Figure 4).
Depress Safety Latch | |
Figure 4 – Depress safety latch to unscrew | |
Ring | 2151 1195 |
b.Hold latch in the release position and rotate ring COUNTERCLOCKWISE to remove. If ring is difficult to turn, tap gently with a rubber mallet to overcome initial resistance.
NOTICE: DO NOT use screwdriver or bladed instrument that may damage shell surfaces to pry tank shells apart.
6.Separate upper and lower tank shell halves using tabs on bottom of
Figure 5 – Insert ring tab in slot in filter body.
Figure 6 – Roll ring to one side to loosen upper tank half.
7.Remove
NOTICE: To avoid strain or damage, allow filter mod- ule to drain before lifting it out of the tank.
SAFETY LATCH (See Figure 7)
The purpose of the safety latch is to hold the
1.Press down on the small catch behind the safety latch and press or tap the latch out of the “Tee” slot in the tank (see Figure 7).
Small
Catch
Figure 7 – Safety Latch
2.Snap the new latch into position.
NOTICE: DO NOT operate the filter if the safety latch is damaged or will not hold the
Assembly:
1.Inspect and clean the tank, ring threads and
2.Install the filter by placing the port in the bottom of the filter cartridge over the tank outlet port. Push down firmly to seal.
3.Ensure that the air bleed assembly on top of the mod- ule is clean and properly mounted.
NOTICE: Lubricate
4.Install the
5.Push the upper tank shell into the lower tank shell to compress the
6.Place the
7.Follow instructions in the “Initial Startup” section of this manual.
7