7.Remove the bulb assembly by pulling on the flow director while pushing the bulb assembly from the outside of the pool.
NOTE
The fitting body, threaded wall flange and gaskets may remain attached to the pool wall when winterizing, but should be removed if pool is to be stored.
8.For storable pools: remove the transformer from its mounting by lifting up and out.
For permanent pools: cover the cord cap on the end of the flexible cord with a plastic bag and seal with a twist tie or rubber band. Wrap the cord into a coil, cover with a plastic bag and seal. Elevate cord to prevent contact with ground moisture.
9.Place all the parts together in a box and store indoors.
When reinstalling bulb assembly next season do not use petroleum base product.
CAUTION
Do not use any petroleum base lubricant. Petroleum base products will destroy plastic parts. Lubricate
SECTION.VII. TECHNICALDATA.
A. REPLACEMENTPARTS.
1. | 79123401 | Lens, ‘Luxury’, blue | 8. | 79116800 | Gasket (2) |
1. | 49300000 | Lens, ‘Luxury’, red | 9. | 83000000 | |
2. | 69100000 | Bulb Assembly |
| 79110700 | Spacer, Mounting |
3. | 79116900 | 10. | 78800100 | ||
4. | 79102800 | Flow Director | 11. | 87370000 | |
5. | 79118300 | Wall Flange, Threaded | 12. | 79401000 |
6.79126900 Fitting Body
7.79116600 Nut
REV. F | 11 | P/N 98748000 |