DUAL THERMOSTAT CONTROL PANEL
THERMOSTAT | L.E.D. Status Lights |
( See page 7 for details.) |
The thermostat dial is just like any other, when you set it at a certain setting the heater will heat up to that temperature and then shut off. When the pool/spa wa- ter temperature drops below this setting the heater will come on and start heating the water back up to the setting on the thermostat.
You will notice there are no number set- tings printed on the dial face. There is a certain procedure to follow to determine the exact temperature you have the ther- mostat set at. This is described further on next pages.
The maximum setting for a thermostat is 104 degrees F. You will only be able to reach this high temperature in a spa ap- plication. Pool temperatures are nor- mally between 78 and 82 degrees F. Ac- tual pool temperatures are determined by your installer, when the unit is sized to your specifications. The lowest setting on the thermostat is around 60 degrees F.
To disable the heater, turn the thermo- stat dial all the way to the left. If you live in a climate where the water tem-
perature may drop below 60 degrees F
you must shut the circuit breaker off.DUAL Thermostat Otherwise do not use the breaker as an
on/off switch.
See "Start up Procedures" regarding compressor preheating if the main power breaker is shut off. The compressor must be preheated for 8 hours after the power supply has been disconnected.
L.E.D. STATUS LIGHT PANEL
The indicator lights will help you determine that the unit is running normally or if there is a condition that may keep the heater from running. Note that the spa light is inactive on single thermostat units. See next page for details on reading the status lights.
6
