Manual flash shooting

Procedure

1 Slide the Power switch to (ON).

2 Set the mode dial to (FULL).

3 Measure the distance to the subject (between the AF200FG and subject) and determine the aperture value using the following procedure. (The Guide No. varies depending on the ISO sensitivity. Refer to the table on page 14.)

Example: If the subject distance (between the AF200FG and subject) is 2.5 m, sensitivity is ISO 100, and the wide-angle panel is not in use, the calculation will become as follows:

The Guide No. will be 20.

Aperture =

Guide No.

20

= 8

Subject distance

2.5

4 Set the lens aperture to the calculated value. 5 Confirmpicture. that the ready lamp is lit. Then take a

13