Performance Teknique ICBM-1-TOUCH manual MP3, Supplementary¸ ½ ¼ Ó × ÊInformationÑ ¶

Models: ICBM-1-TOUCH

1 20
Download 20 pages 32.39 Kb
Page 19
Image 19

Supplementary¸ ½ ¼ Ó × ÊInformationÑ ¶

MP3

Mp3 is the abbreviation of MPEG audio layer3, which is the standard of audio compression technology.

Mp3 files on CD-ROM CD-R and CD-RW can be played in this machine. Disks compatible with ISO9660 level 1 and 2, or with ROMEO and JOLIET system can also be played.

Recorded disks with multi sections can be played.

Mp3 files are incompatible with the transporting of read-in data.

The max char width of the file name (including the extending name .Mp3) is 32 (counting from the first char).

The max char width of the folder name is 32.

If the file is recorded through ROMEO and JOLIET system, only the former 32 char are displayed. While playing disks with Mp3 and CD-DA, such as

CD-EXTRA and MIXED-MODE CD, the system can only switch between Mp3 and CD-DA.

The selected folder sequence of playing and other operations will be the sequence to write in the software. So the anticipated sequence of playing should not conflict with the actual playing sequence. However, there are indeed some softwares in which playing sequence is allowed to set.

The file is compatible with Id3 Label version 1.0 and 1.1, so as to display the music titles and authors. The enhancing function is valid only when playing Mp3 in 32,44.1 and 48 Khz. Sample frequencies 16,22,05,24,32,44.1,48KHz can be played.

The tone of Mp3 file can usually be bettered when the bit rate is increased. This machine can play recordings between 8KBPS and 320KBPS. But in order to enjoy good tone, we recommend disks over 128KBPS.

IMPORTANT:

While naming an Mp3 file, add relevant extending name .mp3.

This machine will play files with .mp3 as Mp3. Do not use this extending name on non-mp3 files so as to avoid noises and other problems.

33

Supplementary¸ ½ ¼ Ó × ÊInformationÑ ¶

Matters to Note about Remote Controller

Do not put the remote on panels, steering wheels, or where with direct sunshine. The temperature in these places are high in summer and the remote may be distorted.

If the car is parked in the sun, put the remote in the tool box or other places away from the sunshine. In the sunshine, the signal from the remote may not be received correctly by the host machine, you have to put the remote near the sensor on the host panel.

About LCD

Do not press LCD, which may distort the pictures or arouse problems. Pictures become blurred, or even the LCD is harmed.

About Cleaning LCD

Use soft cloth with a little water to clean LCD.

Do not use solvents like gas, thinner, detergent in the market or static electricity-resisting sprayer.

Do not use this machine when the temperature is below -15 or over 45.

If your car is parked in a very cold or hot place, pictures may not be clear. This is not the question of LCD. Pictures will become clear again once the temperature comes to normal.

There may appear static blue or red points called bright spots which can appear on any LCD. LCD is a very fine apparatus, 99.99% of

which is normal, with only less than 0.01% defect leading to those points. They will not influence your appreciation of pictures, however.

34

Page 19
Image 19
Performance Teknique ICBM-1-TOUCH manual MP3, Supplementary¸ ½ ¼ Ó × ÊInformationÑ ¶