Fiber Fault Alert (Switch 2)
Switch Position | Mode |
|
|
Up (default) | Enabled |
|
|
Down | Disabled |
|
|
Enabled: If the media converter module detects a loss of fiber signal on its fiber receiver, it will disable its fiber transmitter on the same SFP. This, in effect, notifies the fiber link partner that an error condition exists on the fiber connection.
Disabled: The Protocol Transparent Media Converter module will not monitor for Fiber Fault.
Note: If 2 media converters are connected to each other, FFA should not be enabled on both since this could create a “dead- lock” state.
Rate Select (Switch 3)
Switch Position | Mode |
|
|
Up (default) | High Speed |
|
|
Down | Low Speed |
|
|
High Speed – When a
Low Speed – When a
6
