Installing Protocol Transparent Media Converter Modules
Caution: Observe electrostatic discharge precautions when installing the Protocol Transparent Media Converter module(s) into the chassis. Failure to observe this caution could result in damage to the module(s) and/or chassis.
The Protocol Transparent Media Converter module(s) can be installed in any available slot and in any order within the MCR1900 chassis.
1.Remove the module from its packaging.
2.Using a
3.Set the jumper and DIP switches on the module to the desired operating mode. (optional)
4.Locate the top and bottom alignment guides inside the MCR chassis.
5.Using the module alignment guides gently slide the module into the slot until it becomes flush with the front of the chassis. Light pressure may be needed to seat the module. Do not force the module as you might cause damage. If there is resistance, remove the module and check the module connector for damaged or incorrectly aligned pins. If these are not damaged, retry module insertion.
6.Tighten the captive retainer screw to ensure the module is locked in place.
7.Remove the dust cap from the fiber connectors.
7
