Perle Systems P850 7

Applications

Configuration: The default configuration for P850s shipped outside

North American is to have frame relay disabled. To run frame relay on

these routers, it must first be enabled

7Frame Relay enable

Location: Main

Ä Configuration

Ä WAN Set up

Ä Link Set up

Ä Frame Relay

enabled

The router will request confirmation of the change, enter

“yes”.

For an P850 with a CSU-DSU interface, the default clock speed that

the P850 will expect to receive from the DCE link is 64Kbps. If the

DCE link is 56 Kbps, then the Link Speed value must be reset to 56

here.

7Link Speed

Location: Main

Ä Configuration

Ä WAN Set up

Ä Link Set up

Ä Link Speed

Contents

Main Federal Communications Commission (FCC) Canadian Emissions Standard ICES-003 Page Page Page Page Page Contents 1 - I Unpack the P850 Select a Site Identify the Connectors Connect to the Console Make the LAN Connections Make the WAN Link Connection Page Power Up the Router Login and Enter the Required Configuration Mandatory Configuration Setting the Link Interface Type (Universal WAN only) Setting the T1/E1Parameters (T1/E1 WAN only) Page Page Installation 14 Identify the Status LEDs Rx Power LAN Tx Page 2 - TYPICAL APPLICATIONS & HOW TO CONFIGURE THEM Managing the P850 Using Menus Conventions Basic Frame Relay Configuration 7 Auto Learning the Frame Relay Configuration Manual Configuration - LMI Type 7 Quick Start Frame Relay 7 Basic Leased Line Configuration 7 Quick Start PPP Leased Line Connections 7 Page Should You Bridge or Route? Configure as an Ethernet Bridge 7 Page Configure as an Ethernet IP Router 7 Define an IP Default Gateway 7 Define an IP Static Route 7 Define an IP Subnet Mask Page Page Configure as an Ethernet IPX Router Novell Servers in Both Locations Page Novell Servers in One Location Only 7 PPP Link Configuration Overview Numbered Links Unnumbered Links Configure Dynamic Host Configuration Protocol 7 Page Configure Network Address Translation (NAT) 7 Configure PPP Security 7 Configure Firewall Page 7 Dest IP Address Destination Mask Source IP Address Source Mask Page Configure Remote Site Profiles for PPPoE Page Page Page QOS - Priority Queuing Location: Main Page 3 - INTRODUCTION TO FILTERING MAC Address Filtering Pattern Filtering Page Page Popular Filters Banyan IP Router NetBIOS over TCP Other interesting TCP Ports APPENDIX A MENU TREES Configuration Menu Tree 4] Access Set-Up LAN IPX Set-Up Usage Set-Up Menu Tree software release: F5P6.04.xx Firewall Set-Up LAN / WAN Firewall Set-Up Designated Servers APPENDIX B OCTET LOCATIONS ON ETHERNET FRAMES Page Octet Locations on Ethernet Frames 72 ETHERNET Type Codes Page Page APPENDIX C SERVICING INFORMATION Opening of the case is only to be performed by qualified service personnel. WARNING ! Opening the case Identifying the Internal Components J2 CPU J1 CPU Sanity Timer Force ZMODEM Software Load To Clear a Lost Password Page WAN Interface Connection Pinout Information CSU/DSU V.35 Module: CSU/DSU Module: T1/E1 Module: T1/E1 UNIVERSAL WAN Module: 83 V.35 Link Pinouts Figure C - 6 V.35 Link Pin Outs Page RS232C / V.24 Link Pinouts Con 86 RS530 / RS422 Link Pinouts Figure C-8 RS530 / RS422 Link Pinouts V.11 / X.21 Link Pinouts 88 V.11 / X.21 DB25 to DB15 Connector Cable Page 90 RS232 / V.24 Null-Modem Cable Figure C-12 RS232 / V.24 Null-Modem Cable 91 RS530 / RS422 Null-Modem Cable Figure C-13 RS530 / RS422 Null-Modem Cable APPENDIX D SOFTWARE UPGRADES