Operation
Powering up the Perle Media Converter
1.Connect the Perle supplied power adapter to the media converter.
2.Turn on the power at the source.
3.Check that the PWR LED light is lit.
Terminal Block Connector
1.Ensure the Power Source is off prior to connection.
2.Strip insulator sheathing from both wires 5mm (3/16th inch) to expose the copper conductor wire.
3.Loosen the terminal block screws and connect Positive (+) wire to the left terminal. Connect the Negative
4.Turn on power source.
5.Check that the PWR LED light is lit.
Status LED
There are three status LEDs located on the front of the unit.
PWR
On – Power is applied to the unit
Blinking Fast – Hardware Error
LK1
On – Signal Detected
Off – No Signal Detected
LK2
On – Signal Detected
Off – No Signal Detected
6
