Jeff Rowland Design Group 302 owner manual Detail of Mini-plugConnector

Amplifier Rear Panel Power Connections

Important: Please strictly follow the following steps outlined below in order before operating your Model 302 Stereo Power Amplifier.

KVerify that the VOLTS AC input identified on the rear panel near the AC input socket is the same as the AC mains voltage in your area. If the voltage does not match, DO NOT CONNECT THE AMPLIFIER TO AC POWER and contact your dealer immediately.

LVerify that the AC MAINS circuit breaker is closed (no white area visible on breaker).

MInstall the AC Power Cable between the amplifier and your AC mains outlet.

NConnect the 12V Remote ON/OFF Mini-plug Connector (See Below).

Note: Due to the exceptionally low power consumption rating of the Model 302, it is recommended that the unit not be disconnected from AC mains unless the amplifier is to be moved or reinstalled in another location. It is recommended that the amplifier be placed in Standby mode rather than disconnected from the AC mains power when the amplifier is not in use.

The 12V REMOTE ON/OFF 1/8” (3.5 mm) mini-plug connector (4) is provided on the rear panel of the Model 302 for remotely switching the amplifier between Operational and Standby modes. When connected to another component with the proper circuitry, the amplifier standby function can be turned ON and OFF remotely in a custom installation, theater, or automated system setup. Connection requirements are illustrated below.

Please be aware that the remote feature simply places the amplifier in STANDBY mode and does not disconnect the unit from power or AC mains.

Please contact your dealer for further information about the use and configuration of this feature.

Constant 3V to 15V DC Signal

(12VDC Typical)

Ground

Detail of Mini-plug Connector

17