preparing the cabinet for use
Direct Draw Dispensers Self-Contained
preparing the cabinet for use
Direct Draw Dispensers Self-Contained
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specications without prior notice
3Form No.Z2278
Rev. 11.29.10

connecting the keg coupler (when

supplied by perlick)

■ Place one brown leather washer into black
beer line connector hose on hex nut side.
Screw connector to stainless steel beverage
line on faucet standard. Tighten with a
wrench, but do not over tighten.
■ Make sure level handle on the keg coupler
is in the UP (untapped) position. Place one
brown leather washer into wing nut end of
black beer line connector hose and thread
onto top of keg coupler. Hand tighten.
■ Place clamp on one end of red air line. Push
end over air valve located inside cabinet.
Tighten clamp with screwdriver. Turn shut-off
valve to OFF (horizontal) position.
■ Place clamp on the other end of red air line
and push over tailpiece on coupler. Tighten
clamp with screwdriver.
CAUTION: Do NOT use keg coupler as a
handle to lift keg!

tapping a singl e valve keg (sankey)

■ Be sure beer faucet is in closed position.
■ Align keg lug with lug openings on bottom of
coupler.
■ Turn clockwise 1/4 turn. Pull handle out and
down. Keg is now tapped.
■ Open shut-ff valve on air divider located
inside of the cabinet.
IMPORTANT: Be sure to close this valve
when untapping keg.
OUT
DOWN
1/4
TURN
OUT
DOWN
1/4
TURN
OUT
DO
WN
1/4
TURN
Single Valve
Coupler step 1
step 2
step 3
installing and tapping
Direct Draw Dispensers Self-Contained

electrical

The cabinet must be connected to a separately
fused power source (see electrical specification
plate) and grounded in accordance with National
and Local Electrical Codes.
CAUTION: Do NOT attempt to operate the
equipment on any other power source than
that listed on the electrical specification
plate!
WARNING! To avoid compressor damage,
after returning the cabinet to an upright
position, let unit stand for 24 hours before
plugging it in and running the unit.