5
Unpacking
Procedure
The SXP2 is packaged for maximum protection. To open, sit the
box upright and cut the reinforced tape at the top of the box. The
product can now be removed.
Pull the foam protecting end-caps o ff either side of the unit and
remove the black material covering.
The SXP2 Passive Preamplifier is now unpacked and ready for
further installation.
Note:
Please retain all packaging material for future transport.
Box
Contents
1 x SXP2 Passive Preamplifier
1 x Product manual
3 x Performance analysis charts
Placing Your
SXP2
The SXP2 should generally be placed close to your source
equipment, thus keeping i nterconnect cabling between the SXP2
and associated components as short as practical. This will reduce
the systems susceptibility to radio frequency interference and the
negative effects associated with long cables.
Ventilation
Requirements
The SXP2 is a passive electronic d evice. Ventilation
requirements are not considered an important factor in product
placement.
In the event that the SXP2 is to be incorporated into custom
cabinetry, please refer to the dimensional information provided in
the Physical Dimensions section of the manual (Chapter 12).