12
Note:
The position of the Balanced Input switch has no bearing on the
balanced output, it only selects which input to use for input A
. Set the
Balanced Input switch to ON only when using the balanced input.
..
.
Refer to Chapter 13 “Specifications”, for detail on input sensitivity and
impedance.
Unbalanced Source Inputs
Accepts a standard single-
ended input (RCA) from source components with
single-e
nded analogue outputs. These high quality gold plated sockets are
highly conductive, corrosion resistant, and provide less potential for corrosion
induced distortion.
Caution!
Input D
fixes the output to 0dB, as it is a home theatre bypass. Please
ensur
e the level is suitably attenuated by the upstream processor or
receiver before selecting this input.
Refer to Chapter 13 “Specifications”, for detail on input sensitivity and
impedance.
Tape 1 Line Outputs
This single-ended (RCA) output will provide a
line level audio signal, suitable
for recording, from the selected source input. This output is disconnected when
source input E is selected; to prevent any potentially damaging feedback loops.
Tape 2 Line Outputs
This single-ended (RCA) output will pr
ovide a line level audio signal, suitable
for recording, from the selected source input. This output is disconnected when
source input F is selected; to prevent any potentially damaging feedback loops.
Preamp Output 1
This single-ended (RCA) output is
commonly referred to as “Preamp Out”. It
will provide the audio signal required to drive virtually any amplifier to full
power.
Preamp Output 2
This single-
ended (RCA) output is wired in parallel with M ain Output 1 and is
useful for supplying signal to another amplifier if bi-amping.
Balanced Outputs
This balanced (XLR) preamplifier output provides the signal required to drive
virtually any power amplifier equipped with a balanced input. Connection
should be made with high quality cables fitted with XLR connectors.
Note:
The position of the Balanced I
nput switch has no bearing on the
balanced output; it only selects which input to use for source input A.