Petsafe PDT00-12892, PDT00-12894, PAC00-12893, PAC00-12914 Key Definitions, Handheld Transmitter

Key Definitions

Handheld Transmitter:

Transmits the radio signal to the Receiver Collar. It is water resistant.

Transmitter Indicator Lights: Indicate that a button is pressed and also serves as a low-battery indicator.

Red LED: Factory set for single dog training. Indicates low battery and when any blue correction button is pressed. Also indicates when Transmitter is charging.

Green LED: For 2 Dog training. Indicates when any blue correction button is being pressed for Dog 2.

Antenna
		Level Select
		Switch
	Dog Select	Level Select
	Button	Indicator
Top Button	Transmitter
(light blue)	Indicator Lights:
		Red LED
Middle Button		Green LED
(medium blue)		(for 2 Dog)
Bottom Button		Battery
(dark blue)		Door Cover
Wrist Strap	Charging Jack
Attachment	& Dust Cover

Level Select Switch: Provides multiple levels of Stimulation. Note: When set to Level “0”, the LED’s on the Receiver Collar will still light up but no correction will be delivered.

Level Select Indicator: Shows level of correction.

Correction/Stimulation Buttons: Deliver Vibration Correction and/or Static Stimulation, depending on model.

Top Button (light blue): On models PDT00-12892 and PDT00-12894. Delivers a quick Vibration Correction followed by a Controlled (continuous) Vibration when button is pressed. Middle Button (medium blue): On model PDT00-12894. Delivers a quick Vibration Correction followed by a Controlled (continuous) Static Stimulation when button is pressed. A safety time- out will be triggered if the button is held continuously for more than 12 seconds. The safety time-out will end when the button is released.

Bottom Button (dark blue): On model PDT00-12894. Delivers a quick Static Stimulation followed by a Controlled (continuous) Static Stimulation when button is pressed. A safety time- out will be triggered if the button is held continuously for more than 12 seconds. The safety time-out will end when the button is released.

Dog Select Button: Used to select between Dog 1 and Dog 2.

Wrist Strap Attachment: Used to attach Wrist Strap.

Antenna: Transmits signal from the Handheld Transmitter to the Receiver Collar.
Charging Jack & Dust Cover: Used to charge the Handheld Transmitter and should always be
closed when charger is removed.
Battery Door Cover: In the event that batteries are not charging properly, please contact our
Customer Care Center.
Vibration Stimulation: Activates the Vibration in the Receiver Collar.
Static Stimulation: You control when and how long Stimulation is delivered to your dog through
the Receiver Collar’s Contact Points. When a Static Stimulation button is held for 12 seconds
or more, the Red or Green LED will flash (depending on Dog 1 or Dog 2 mode), indicating it is in
safety time-out mode. The button will need to be released and pressed again before additional
Stimulation can be delivered.	www.petsafe.net	5