Re-synchronize the System
1.Remove the Receiver Collar from your pet.
2.Remove the battery from the Receiver Collar. Discharge all power by holding the correction level button down until the LED is no longer illuminated.
3.At the transmitter, move the Boundary Switch from the low to the high position.
4.Slowly adjust the Boundary Control Dial up to 8, down to 1 and then back to the #4 position.
5.Standing within
6.Test the Boundary and verify operation by walking out into the Pet Area until your Receiver Collar responds. (With the Transmitter set to 4, it should activate approximately
Once you are confident that the system is working, reset the Transmitter controls to the original setting.
Terms of Use and Limitation of Liability
1.Terms of Use
This Product is offered to you conditioned upon your acceptance without modification of the terms, conditions and notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and notices.
2.Proper Use
This Product is designed for use with pets where training is desired. The specific temperament of your pet may not work with this Product. If you are unsure whether this is appropriate for your pet, please consult your veterinarian or certified trainer.
3.No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm, injure or provoke. Using this Product in a way that is not intended could result in violation of Federal, State or local laws.
4.Limitation of Liability
In no event shall Radio Systems® Corporation be liable for any direct, indirect, punitive, incidental, special or consequential damages, or any damages whatsoever arising out of or connected with the use or misuse of this Product. Buyer assumes all risks and liability from the use of this Product.
5.Modification of Terms and Conditions
Radio Systems® Corporation reserves the right to change the terms, conditions and notices under which this Product is offered.
20 |