Display position is incorrect
Push the Auto button.●
Adjust the image position using the Horizontal
Position &/or Vertical Position in OSD Main
Controls.
●
Image vibrates on the screen Check that the signal cable is properly connected
to the graphics board or PC.
●
Vertical flicker appears
Push the Auto button.●
Eliminate the vertical bars using the Clock
Adjustment of VIDEO NOISE in OSD Main
Controls.
●
Horizontal flicker appears
Push the Auto button.●
Eliminate the horizontal bars using the Phase
Adjustment of VIDEO NOISE in OSD Main
Controls.
●
The screen is too bright or too dark
Adjust the contrast and brightness in OSD Main
Controls. (The backlight of the LCD monitor has a
fixed life span. When the screen becomes dark or
begins to flicker, please contact your dealer.
●
An after-image appears
If an image remains in the screen for an extended
period of time, it may be imprinted in the screen
and leave an after-image. This usually disappears
after a few hours
●
An after-image remains after the power
has been turned off.
This is characteristic of liquid crystal and is not
caused by a malfunction or deterioration of the
liquid crystal. The after-image will disappear after
a set amount of time
●
Green, red, blue, dark, and white dots
remains The remaining dots are normal characteristic of
the liquid crystal used in today’s technology.
●
For further assistance, refer to the Consumer Information Centers list to contact your local Philips
distributor.
RETURN TO TOP OF THE PAGE
Troubleshooting
file:///D|/K1/english/180p2m/safety/saf_troub.htm (2 of 2) [3/26/2003 11:00:27 AM]