Press the Navigation buttons to select [Installation] > [Decoder] > [Channel].

Insert and activate a CAM

Caution

Be sure to follow the instructions described below. Wrong insertion of a CAM may damage both the CAM and your TV.

1 Switch off the TV.

2 Following the directions printed on the CAM, gently insert the CAM into the COMMON INTERFACE at the side of the TV.

3 Push the CAM in as far as it will go.

4 Turn on the TV and wait for the CAM to be activated. This may take several minutes. Do not remove the CAM from the slot when in use — removing the CAM will deactivate digital services.

Access CAM services

1 After inserting and activating the CAM, press OPTIONS.

» The options menu appears.

2 Press the Navigation buttons to select [Common interface].

3 Press OK.

» A list of CAM applications appears.

4 Press the Navigation buttons to select a CAM application.

5 Press OK » The selected CAM application is

enabled.

Assign a channel decoder

Before using a SCART digital channel decoder, select the channel to decode and assign the decoder to EXT 1 or EXT 2.

1 While watching TV, press (Home).

»The home menu appears.

2 Press the Navigation buttons to select [Setup].

3 Press OK.

»The [Setup] menu appears.

4

5 Press the Navigation buttons to select [Status], then the location of the decoder (eg. EXT 1 or EXT 2).

6 Press OK

»The decoder is assigned.

Use Philips EasyLink

Your TV supports Philips EasyLink, which uses the HDMI CEC (Consumer Electronics Control) protocol. EasyLink-compliant devices that are connected through HDMI connectors can be controlled by a single remote control.

Note

Philips does not guarantee 100% interoperability with all HDMI CEC devices.

Note

The EasyLink-compliant device must be switched on and selected as the source.

36EN