5.8 3D
3D
This TV is prepared for the 3D Full HD accessory PTA02 (sold separately -
only for
PTA02 Installation
1 Switch off the TV.
2 Connect the 3D transmitter to the 3D connection 3D Out on the back of the TV.
3 Install the 3D transmitter on the top or at the bottom of the TV. Make sure to point the transmitter directly to where you sit to watch TV.
The small window in the middle of the glasses receives the 3D signals from the transmitter.
Update the TV software
To prepare your TV for 3D watching, you must update the TV software.
1 Switch on the TV.
2 Plug in the USB device in the USB connection at the side of the TV.
3 The software update will start automatically and during the update the TV might switch off and on again. Do not press any key on the remote control and wait until the message ‘Operation Successful’ appears.
4 Unplug the USB device and switch the TV off and back on again.
Your TV is ready to watch 3D.
Connections / 3D | 69 |
Downloaded From
